included in designer’s specification by reproduction, but shall be used as a guide the designer’s part.……………………………………………….
ols……………………………………………………………….
ing………………………………………………………………….
……………………………………
………………………………………………………….
……………………………………………………………
…………………………………………………………
……………………………………………………………………..For the purpose of clarification “standard symbols” can be found in current editions of the Architectural Graphic Standards, the American Electricians’ Handbook, and in the IEEE
downstream protective devices. It is the engineer’s responsibility to make “working drawing” after the design engineer approval of the vendor “shop rawings” final coordination study based on the protective device vender chosen for the project
In addition, equipment shall be installed in accordance with the manufacturer’s s’Disconnects for the elevator and the elevator’s car shall be provided and installed by the ing indelible ink. The cable identification shall indicate “ type, voltage rating, KV% insulation level& sequential footage number.”Manufacturer’and shall contain the following information, manufacturer’s name & location, cable trade name,
In special cases, type “AC” and type "NM" cables are permitted provided the Power and lighting circuits’ minimum conductor sifault receptacles shall be provided for the entire “Dormitory” except in the bathroom and the
and shall be "approved” third party listed as "rainthickness of the common ground bus shall not be less than 2”*1/4”.category “ “shall be mounted at the Transformer, Category “2” ategory “ ” shall be mounted at the ategory “ ” shall Location of the Power Utility’s pad mounted transformer shall comply with ANSI/IEEE 979.“ ”Ballast to be "U/L Listed, Class P", “Sound Rated A”, and meet or exceed ANSI C82.11
At the end of the study, provide summary of the engineer’s conclusion of the best option to Section “E 02” items 3.3,
disconnect shall be labeled and located next to the room’s local switch, and shall be within sight that the generator’s backpressure specification is not exceeded.hall be mounted on top or side of the generator and enclosed in a “NEMA RATED” enclosure. A builtGenerator’s control panel specifications shall be per NFPA 110 requirements.
Copy of the generator’s load test report shall be sent to the engineer of record, the owner, protection should be rated for “Lightning Surges”.
“Fire Detection and Alarm Systems” guidelines and criteria only for the purpose of preparing the designer’s plans and specifications for the specific project in their contract. The document is not designer is not to insert the document “as is” into the specifications. The designer is to revise